Every hot tub needs to be taken care of in the long run. To get the right hot tub repair services, you need to make sure that they have the professionals who know how to do the work properly. Maintaining the tub in the right condition increases its shelf life, giving you years of trouble free service. The hot tubs Edmonton cost are competitively priced across the range and you can have a comparison before getting the tub serviced by any dealer. Here are few things that you need to take care of.
- Replacing cracked pipes and fittings
When you use the tub fro longer duration of time, the pipes and the fitting of the tubs take a beating. If you see any leakage on the pipe then first disconnects all the electrical supply to the tub. Then wear protective gloves and using a hacksaw, cut the leaking part of the pipe and the fittings. To join the new set of pipes, use the PVC primer and the cement to get the job done.
- Pipe repair
Sometime the leaking pipe can be repaired and you don’t have to change the whole pipe for it. To repair a leaking epoxy, use the sealant around the leaking pipe and let it dry naturally, make sure you are using an adequate pair of gloves before using the sealant. The coat of the sealant should be thick and cover every cracked area on the pipe. Follow the instruction on the sealant and let it dry for few hours before you start to use the spa.
- Pipe seals
The leaking joint of the pipe can be taken care of by using clip on pipe seals. Many hot tub repair in Sherwood park use this technique to get rid of the leaking joints. To add the clip on seal, clean the joint from any water deposits by using a cleaning agent or sandpaper. After cleaning it thoroughly, apply a thin coat of PVC sealant and add the clip on to the joint. Allow the sealant to dry for 24 hours and the clip on to set before using the spa tub.
- Re sealing the jets
The jets on the spa tub are connected with a supply pipe that provides them with the needed pressure water. Over the time of usage, the jets develop a leak and the pressure is lost. In this case, you need to re seal the jets so that the original pressure is retained. The hot tub repair services recommends checking the jets once every year to make sure their pressure is up to the mark. The jets can be re-sealed using a silicon gel. Apply a required amount of the gel on the site of the jet and push the jet back firmly into the socket. Tighten all the screws and let it set for 24 hours before you start to use the tub again.